2002 DMT BOPP Line

Number of layers: 3

Material: BOPP

Output: 2800kg/h

Width: 6800mm

Extruder 1: Davis Standard, co extruders with maximum output 150kg/hr and 200kg/h DC drive, 02 co extruder motors stand by L/D30:1 included with double filters with surface area 0.81m2/unit

Extruder 2: twin screw extruder, TM133MW, 2800kg/h, melt pump Maag, AC drive main filter: L.666 surface area: 6.36 m2

Extruder 3: co extruders Davis Standard, 2 co extruders with maximum output 150kg/hr and 200kg/h DC drive, 02 co extruder motors stand by L/D 30:1

Included with double filters with surface area: 0.81m2/unit

MDO: 14 pre heating rolls, electrical heaters, 4 stretching rolls, circulating oil, 2 annealing rolls, electrical heaters, 5 nip rolls, AC drive, stretching ratio 1:1-1:6

TDO: chain and chain track system, heating system circulating air via individual heating system/zone electrical heater, motors, fans, sensor, etc., edge guide system at inlet

Pull roll unit: cromed rolls chilled by water, edge trim on line recycling unit, 2 corona treatment stations up and down double treated, AC drive thickness gauge x ray, measurement range 5-100micron

Rewind: turret automatic change

Atlas slitter and rewinder: 6.8m, 1000m/min CW964 10 stations

Maximum mechanical speed: 280m/min

Edge recycling system

Pneumatic conveying system

Cyclone to separate resin and conveying air

Metal separator

Mixing hopper

Suction conveying for co extruder

Edge trim recycling

Edge trim grinder

Conveying fans

Recycling system: Erema 500kg/h RM80T

Utilities: compressor, boiler, silos, mill rolls, mill roll stands corona and nip, nip rolls stands,

overhead crane 10TM